Routing

Std. router is 2.4mm, except for polyimide laminate, here 1.4mm is std.

Minimum router is 0.8mm. Routing tolerance ±0.10mm

Please design a gerber-layer that represents the board contour, where the centre of the track is the edge of the boardIt would be preferred if gerber circle commands as G74 and G75 is supported when corners are rounded.

Scoring V-cut or scoring is available
0.4mm scoring, 0.8mm to nearest copper from scoring centre line.

Depth controlled routing

It is possible to get the board edge thinner, due to rack mounting.